Ask
Reply
Solution
11-11-2013 01:31 PM
Hi everyone, my v2 was recently replaced with a v3 under warranty, I have registered it and all appears ok, all of the lights are lit but the phones that are linked to it don't have a full signal. One is an iPhone 5 with 4/5 bars, and the other is a Nokia Lumia 1020 that is registering 4 bars with H.
My question is - if the SS is working properly, should the handsets that are linked with it show a full 5 bars? Should that also show 3G or 4G?
Thanks for reading.
04-12-2013 03:57 PM
Hi
I haven't had time to take this to a friends house to try it out (I work full time and have two young kids so this isn't an ideal option). If there is any other way you can test to see if this unit is faulty or not I would like to try that option.
Yesterday I was on a call and the signal dropped completely, cutting me off. It took me 2-3 minutes to reconnect the call, my iPhone kept saying Call Failed.
When I checked my VSS, the red power light was solid, the first white light was slowly flashing. Once I was able to connect a call from my phone, I watched the VSS and no additional lights came on when the call connected.
Please advise what needs to happen next - I really just want to get this sorted so I can use my Vodafone handsets at home.
Thanks.
05-12-2013 05:47 PM
Hi dannyyoung,
There isn't really an equivalent test. If it works on a different connection, we know the box is fine and something in the set-up is the issue. That's something we can't distinguish between from this end
I've tried a resync, so reset the Sure Signal following these steps:
If that fails, I'd like to check that the speeds aren't dropping too low. Post the following for me:
On a PC
- Click on Start and select Run.
- Type CMD into the Run box and press enter/click ok.
- A black box will appear.
- In this box type tracert 212.183.133.177 and press Enter.
On a Mac
- Open Terminal (Applications, Utilities).
- Type traceroute 212.183.133.177 and press Enter.
Dave
06-12-2013 09:12 AM
Dave @ Vodafone,
The OP is not the only one experiencing this issue, this is a common issue experienced by many V3 users. The fact that i've tried four (yes FOUR!!!) brand new V3 Sure Signals and every one of them gives me intermittent disconnections proves the V3 has a design fault somewhere...yet my old rusty V2 works flawlessly. I really think you need to look deeper into this. As i said in a different post, not everyone using a V3 is going to report this as the disconnections can happen a few times each day or once every few days. so some people will just shrug this off and accept them. The V3 needs to be taken to a laboratory and dissected and see which of its innards are at fault.
07-12-2013 09:25 AM
Right, here is the latest instalment, as the VSS has stopped working again. I now have the following issue:
Power: Flashing
Internet: Off
In Service: Solid Orange
In Use: Solid Orange
Cause
This light sequence indicates the VSS is not active and it has been unable to authenticate on the Vodafone network
I have restarted the VSS and the same light pattern is showing again.
I will try and find time to run the tests suggested, I have my two young sons here so it isn't that straightforward.
To say I am losing my patience with this is an understatement, the support on these units is poor, it takes far too long to get issues resolved. I just want to be able to use my mobile phone at home!
07-12-2013 09:58 AM
OK here are the results:
Speedtest results - ping 61ms, download speed 9.71Mbps, upload speed 0.79 Mbps
Ping test - packet loss 0%, ping 40ms, jitter 1ms, line grade A
Microsoft Windows [Version 6.3.9600]
(c) 2013 Microsoft Corporation. All rights reserved.
C:\Users\danny>tracert 212.183.133.177
Tracing route to cluster4.vap.vodafone.co.uk [212.183.133.177]
over a maximum of 30 hops:
1 1 ms 1 ms 1 ms 192.168.2.1
2 * * * Request timed out.
3 46 ms 39 ms 45 ms ip-84-38-37-52.easynet.co.uk [84.38.37.52]
4 89 ms 82 ms 128 ms ae99.edge3.London2.Level3.net [212.187.201.57]
5 247 ms * 40 ms ae-0-11.edge4.London2.Level3.net [4.69.200.126]
6 40 ms 39 ms 40 ms ae-3-3.ebr1.London1.Level3.net [4.69.141.189]
7 40 ms 58 ms 40 ms ae-44-44.ebr1.London1.Level3.net [4.69.167.30]
8 39 ms 40 ms 41 ms ae-58-113.csw1.London1.Level3.net [4.69.153.122]
9 40 ms 44 ms 72 ms ae-120-3506.edge4.London1.Level3.net [4.69.166.5
]
10 43 ms 41 ms 43 ms 195.50.122.66
11 45 ms 41 ms 44 ms 85.205.116.14
12 * * * Request timed out.
13 * * * Request timed out.
14 * * * Request timed out.
15 * * * Request timed out.
16 * * * Request timed out.
17 * * * Request timed out.
18 * * * Request timed out.
19 * * * Request timed out.
20 * * * Request timed out.
21 * * * Request timed out.
22 * * * Request timed out.
23 * * * Request timed out.
24 * * * Request timed out.
25 * * * Request timed out.
26 * * * Request timed out.
27 * * * Request timed out.
28 * * * Request timed out.
29 * * * Request timed out.
30 * * * Request timed out.
Trace complete.
C:\Users\danny>
07-12-2013 10:08 AM
I have powered down and powered up the VSS again and I am still getting the same light sequence as before, power led flashing, the last two lights on orange. This is the worst it has been since this whole saga started.
10-12-2013 08:31 AM
Hi dannyyoung,
Everything is fine with your speed test and ping test.
Hop 5 on your traceroute is a cause for concern. There’s a high reading (247ms) and a timeout on the same line.
Can you rerun the test when it’s convenient and see if it changes?
Also, check to make sure you have the following ports open on your router:-
Port Number
8 TCP UDP
50 TCP UDP
53 TCP UDP
67 UDP
68 UDP
123 UDP
500 UDP
1723 TCP UDP
4500 UDP
33434 - 33445 UDP
The other thing to try would be a different Ethernet cable to see if this helps.
Let me know how you go on.
Cheers,
Andrew
11-12-2013 08:43 AM
Hi Andrew
Thanks for the reply. Here are the tracert results again:
Microsoft Windows [Version 6.3.9600]
(c) 2013 Microsoft Corporation. All rights reserved.
C:\Users\danny>tracert 212.183.133.177
Tracing route to cluster4.vap.vodafone.co.uk [212.183.133.177]
over a maximum of 30 hops:
1 1 ms 1 ms 3 ms 192.168.2.1
2 * * * Request timed out.
3 41 ms 38 ms 46 ms ip-84-38-37-52.easynet.co.uk [84.38.37.52]
4 42 ms 41 ms 54 ms ae99.edge3.London2.Level3.net [212.187.201.57]
5 39 ms 40 ms 40 ms ae-0-11.edge4.London2.Level3.net [4.69.200.126]
6 39 ms 39 ms 39 ms ae-3-3.ebr1.London1.Level3.net [4.69.141.189]
7 40 ms 41 ms 39 ms ae-44-44.ebr1.London1.Level3.net [4.69.167.30]
8 40 ms 39 ms 39 ms ae-56-111.csw1.London1.Level3.net [4.69.153.114]
9 42 ms 42 ms 40 ms ae-120-3506.edge4.London1.Level3.net [4.69.166.5
]
10 61 ms 60 ms 62 ms 195.50.122.66
11 60 ms 56 ms 60 ms 85.205.116.6
12 * * * Request timed out.
13 * * * Request timed out.
14 * * * Request timed out.
15 * * * Request timed out.
16 * * * Request timed out.
17 * * * Request timed out.
18 * * * Request timed out.
19 * * * Request timed out.
20 * * * Request timed out.
21 * * * Request timed out.
22 * * * Request timed out.
23 * * * Request timed out.
24 * * * Request timed out.
25 * * * Request timed out.
26 * * * Request timed out.
27 * * * Request timed out.
28 * * * Request timed out.
29 * * * Request timed out.
30 * * * Request timed out.
Trace complete.
C:\Users\danny>
Can you please let me know how I check the ports on my Netgear router? I can access the router setup through the IP address but I can't find where to check specific ports.
I'm using the ethernet cable that came with the VSS, I have another one and will try that, if it makes any difference I will post up a reply.
Cheers
Danny
12-12-2013 09:39 AM
Hi Danny,
That traceroute looks fine.
You can find out how to check the ports on your router here.
Let me know how you get on.
Cheers,
Andrew
21-12-2013 10:28 PM